How to establish the connection between Android phone and Q-Watch ?

A .Please follow the procedures below. Check if the Android version of your phone is Android 4.4 above, and if it does support Bluetooth 4.0 Low Energy? You may refer to here to see more compatible devices.

To determine what version is running on your device, select "Settings > About Device".


B. After you checked above, please follow the instructions below to wear the Q-Watch device and connect with i-gotU Life app:

(1). Please download and install i-gotU Life app on your phone:

Please ensure that you have correctly worn the Q-Watch device . Please refer to the user manual to help you wear correctly.
Q-Watch device online user manual:

(2). After wearing your Q-Watch device , please open i-gotU Life app and click "Yes. First time" to start the installation.
If you have installed this Q-Watch device with any other phone before, please click "No, Not first time" .

(3). Please notice that: Please make sure your Q-Watch device is fully charged when used for the first time.
It takes about 3 hours before it is fully charged. If you have not done that, Q-Watch device would not be started normally.
If you select "Yes, Fist time", please click "NEXT" button, and skip to Step(4).

If you select "No, Not first time", please continue to do "Check Device Status" and "Reset Device Settings".

[Check Device Status]
Please switch Q-Watch device to Daily mode, and make sure the signal strength icon does not appear.
Please tap "here" if the signal strength icon appears.

[Reset Device Settings]
Reset your Q-Watch device device, please refer to the FAQ > Product Operation > Q1.

(4). If you have not turn on your phone Bluetooth function, it will ask you to turn it on. Please tap "Allow".

(5). After turning on Bluetooth, i-gotU Life will start to search your Q-Watch device .
(Q-82 device will appear"Q-Watch R", Q-90 device will appear "Q-Watch Z")

If your phone Bluetooth cannot search Q-Watch device , please try the followings:
1. If your Android version is v6.0.x and above, please enable the Location service(GPS).
2. Please tap the Q-Watch device button twice and then back to App and scan again.

(6). When searching your Q-Watch device , please tap on it. It will be connected automatically.

(7). Please press the button of your Q-Watch device twice in 30 seconds in order to confirm the connection of the device.

(8). Now, Q-Watch device is connected. Please tap "NEXT".

(9). You have to input the correct personal information, or it will not analyze your sport data accurately.

(10).i-gotU Life will auto-detect the firmware version of Q-Watch device , please click "NEXT" to upgrade to the latest version.
Q-Watch device will connect to server and check the firmware version when the Q-Watch device has first connected with phone successfully, please make sure Wi-Fi or Mobile network of your phone has been turned on.

(11). When upgrading the firmware and changing device language. Please be patient to wait and not to close the app.

(12). If you would like to transfer the notification from phone to your Q-Watch device , please click "Settings" to enable the Notification function.

(13).The program will go into the main page of the app, it will show "Connected" on the left top. You can start to use i-gotU Life.