How to establish the connection between iPhone and Q-Watch device?

 

(1). Please search and install i-gotU Life app from your iPhone App Store:
You may also download from our website:
http://global.mobileaction.com/download/Q-Band_download.jsp

(2). Please make sure your Q-Watch device is fully charged before connecting with it.
Note: Q-Watch device has power protective design before the connection. It has to be fully charged, otherwise it cannot be connected and prompted firmware upgraded.

(3). Please open i-gotU Life app on your iPhone, and enable Bluetooth function.
When you install the i-gotU Life App first, the app will pop the Notification window, please tap "Allow" to continue next step.

(4). First time install the i-gotU Life, please tap "Yes. First Time" to start the installation.
If you have installed this Q-Watch device with any other phone before, please tap "No, Not first time"

(5). Please make sure your Q-Watch device is fully charged when used for the first time.
It takes about 2 hours before it is fully charged.
If you select "No, Not first time", please continue to do "Check Device Status" and "Reset Device Settings"

[Check Device Status]
Please switch Q-Watch device to Daily mode, and make sure the signal strength icon does not appear.

[Reset Device Settings]
Reset your Q-Band/Q-Watch device, please refer to the FAQ > Product Operation > Q1.

(6). Please tap the button on your Q-Watch device to turn on device and make it visible for devices scan via Bluetooth connection.
When Bluetooth searched Q-Watch device, please tap on it. It will be connected automatically.
(Q-82 device will appear"Q-Watch R", Q-90 device will appear "Q-Watch Z").

Note:
1. If your phone Bluetooth cannot search Q-Watch device, please tap the Q-Watch device button twice and then back to App and scan again.
2. Q-Watch device will connect to server and check the firmware version when the Q-Watch device has first connected with phone successfully, please make sure Wi-Fi or phone network of your phone has been turned on.

(7). After your Q-Watch device and iPhone connected, please tap the button on Q-Watch device twice in 30 seconds to confirm your Q-Watch device.

(8). When Q-Watch device is connected, it will show its Serial Number and firmware version.

(9). Please fill your personal information when using for the first time.

(10). i-gotU Life will auto-detect the firmware of Q-Watch device,
please tap "Upgrade" to upgrade to the latest version.

(11). When upgrading the firmware and changing device language, please be patient to wait and not to close the app.

(12). Q-Watch device is set up successfully.

(13). Please continue to practice the mode switching,
please follow the steps to practice, and tap "Exit" to go back to main page.

(14). Please tap "Pair" to make sure the Bluetooth connection between Q-Watch device and your phone.
Then the i-gotU Life app will go into the main page of the app, it will show "Connected" on the left top. You can start to use i-gotU Life.