How to establish the connection between iPhone and Q-Band / Q-Watch?
(1). Please search and install
i-gotU Life app from your iPhone App Store:
You may also download from our website: http://global.mobileaction.com/download/Q-Band_download.jsp
(2). Please make sure your
Q-Band / Q-Watch is fully charged before connecting with it.
Note: Q-Band / Q-Watch has power protective design before the connection. It has to be fully charged, otherwise it cannot be connected and prompted firmware upgraded.
(3). Please open i-gotU
Life app on your iPhone, and enable Bluetooth function.
(4). First time install the i-gotU Life, please click "Yes.
First Time" to start the installation.
If you have installed this Q-Band / Q-Watch with any other phone before,
please click "No, Not first time"
(5). Please make sure your
Q-Band / Q-Watch is fully charged when used for the first time.
It takes about 2 hours before it is fully charged.
If you select "No, Not first time", please continue to do
"Check Device Status"
and "Reset Device Settings"
[Check Device Status]
Please switch Q-Band / Q-Watch to Daily mode, and make sure the signal
strength icon does not appear.
[Reset Device Settings]
Reset your Q-Band/Q-Watch device, please refer to the link below.
http://global.mobileaction.com/support/sub-Q-66/F2-13.htm
(6). Please press the button
on your Q-Band / Q-Watch to turn on device and make it visible for devices
scan via Bluetooth connection.
When Bluetooth searched Q-Band / Q-Watch, please click on it. It will
be connected automatically.
Note:
1. If your phone Bluetooth cannot search Q-Band / Q-Watch, please click
the Q-Band / Q-Watch button once and then back to App and scan again.
If it still does not search anything, please charge your Q-Band / Q-Watch
for 10 seconds to remove power protective mode... and scan again.
2. Q-Band / Q-Watch will connect
to server and check the firmware version when the Q-Band / Q-Watch has
first connected with phone successfully, please make sure Wi-Fi or 3G
network of your phone has been turned on.
(7). After your Q-Band /
Q-Watch and iPhone connected, please press the button on Q-Band / Q-Watch
twice in 30 seconds to confirm your Q-Band / Q-Watch.
(8). When Q-Band / Q-Watch
is connected, it will show its Serial Number and firmware version.
(9). Please fill your personal
information when using for the first time.
(10). i-gotU Life will auto-detect
the firmware of Q-Band / Q-Watch,
please click "Upgrade" to upgrade to the
latest version.
(11). When upgrading the
firmware, it needs to take around 10~15 minutes.
Please be patient to wait and not to close the app.
(12). Q-Band / Q-Watch is
set up successfully.
(13). If you would like to transfer the notification from phone to
your Q-Band / Q-Watch, please click "OK" to enable the Notification
function.
(14). Please click "Pair" to make sure the Bluetooth connection
between Q-Band / Q-Watch and your phone.
Then the i-gotU Life app will go into the main page of the app, it will
show "Connected" on the left top.
You can start to use i-gotU Life.
If your Q-Band / Q-Watch is touch screen, please continue to practice
the mode switching,
please follow the steps to practice, and click "Exit"
to go back to main page.